Flush, monolithic, reinforced flooring. Thickness of 5/10cm. Surface layer of approx. 10mm.
This floor is anchored to a cured concrete plate.
Standard UNI 11146 - Chapter 4.44

DESCRIPTION
High strength flush monolithic floor with concrete load bearing plate. Application Terminology: "Facing" obtained by applying an anti-wear surface layer as a mortar of approx. 10mm on DURSICAL 5-10 concrete layer of between 5 and 10cm thickness.

WHERE IT IS APPLIED
Flush monolithic flooring. Welded to the concrete load bearing plate Suitable for loads (lI) and operations (M-P) (See DIN Standard 1100) Heavy industry, intensive warehousing, offices etc..

SPECIFICATION FOR THE DESIGN
DURSIL 5-10 monolithic industrial flooring comprising:

1. SURFACE LAYER
   A mixture based on spheroidal quartz and hard minerals with the addition of special binders, with a homogeneous granulometric curve of between 0.125 and 3.0mm, in ratio of 10-12 kg per m² Mixed with water with 7Kg of cement per m² The compound is applied as mortar on fresh concrete and then finished
2. LEVELLING CONCRETE PLATE
   DURSICAL 5-10 concrete plate with a thickness of between 5 and 10cm. (Formulated and reinforced concrete to achieve the performance required by the design of the project. Resistance, durability and controlled shrinkage are basic elements of DURSICAL). Thickness reinforcement require a design project
3. EXISTING CONCRETE PLATE
   Existing cured concrete plate Cleaned of any impurities using mechanical equipment that roughens the surface.
4. SUPPORTING BASE
   TSoil stabilised using the Westergaard method